|
Post by bikerbill on Sept 21, 2010 1:32:25 GMT -5
A question on Transmission oil top up.
By the rear brake pedal on the side casing their is a 6mm screw/bolt with a fiber washer, if the bike is on the center stand is that the level plug? another words do you fill it up until the oil comes out of the hole??
Also I've replace the front sprocket oil seal (the sprocket was loose!!) but still have a bit of a leak, do the gear position sensors leak sometimes??
|
|
|
Post by steveuk on Sept 21, 2010 3:24:21 GMT -5
Hi Bil
yes fill it until it cones out of the hole, the gear position sensor has an oring which could fail, check that the 2 screws are tight if not just change the oring cost a small amount, lean the bike up a wall on its right hand side this should minamize oil lose when you remove the sensor
steve
|
|