|
Post by mazdaman on Feb 12, 2024 18:45:15 GMT -5
So as most know it’s getting harder and tougher to find NOS parts. So I decided to try my hand out on making a Gasket out of a roll of Rubber gasket material. I think it turned out pretty good. And it appears to be really close to the same thickness too. If it works out .I’d be willing to help anyone out and make them one. Here’s a link to my iCloud to see the photo share.icloud.com/photos/096yJhvo1dYq-KQpO5jk1JyKA
|
|
|
Post by janski on Feb 13, 2024 6:27:34 GMT -5
I also attempted this for the carb but when problems occurred I discovered the material I used had swollen with the fuel, I know I'm not alone in attempting this, I believe the correct quality/thickness of paper gasket is best, this has been mentioned in detail earlier on this forum. Best of luck with your RE.
|
|
|
Post by hudson on Feb 13, 2024 9:05:12 GMT -5
Mazdaman
Member t140v ( Stuart ) has produced an excellent float bowl gasket, he has worked out the right material and thickness at a very reasonable price. I have been using these for years with complete success. You can send him a P/M through messages on this site or his e-mail is listed under his profile.
Brian
|
|