|
Post by rdragoo on Mar 15, 2023 20:31:24 GMT -5
|
|
|
Post by multistrada1 on Mar 15, 2023 20:59:40 GMT -5
At that price, just get one and match it up.
Make sure the hole in the needle jet is the same size and the installed height of the part is the same as the factory part.
|
|
|
Post by rdragoo on Mar 15, 2023 21:06:07 GMT -5
Good points. Original NOS Suzuki units have gotten pricey. I'm going to order one and I'll report back after a careful comparison.
|
|
|
Post by h2e Al In Aus on Mar 16, 2023 16:10:20 GMT -5
hi I used a needle and seat for a L300 mitsubishi van same as they used a mikuni solex carby aswell
|
|
|
Post by rdragoo on Mar 16, 2023 23:19:25 GMT -5
Thanks, that's good info
|
|
t140v
3rd Gear
Posts: 422
|
Post by t140v on Mar 19, 2023 13:18:39 GMT -5
Make sure its a size 3 or you could empty the float chamber if its smaller. Regards Stuart
|
|
|
Post by timpa136 on Mar 19, 2023 13:44:31 GMT -5
I was thinking along those same lines, is there any downside to having a larger opening all things being the same?
Tim
|
|
|
Post by CanAm on Mar 20, 2023 4:50:09 GMT -5
Do we know the original part number as there is a lot listed around the world....
|
|
t140v
3rd Gear
Posts: 422
|
Post by t140v on Mar 20, 2023 13:47:02 GMT -5
Do we know the original part number as there is a lot listed around the world.... It will be a mikuni size 3 take the old one out and measure it up, thread diameter and pitch and make sure unthreaded bit is the same length as original.
|
|