t140v
3rd Gear
Posts: 422
|
Post by t140v on Aug 30, 2014 18:37:00 GMT -5
It can be replaced. Sorry can't post any more have reached my limit. |
|
|
|
Post by wayne on Aug 31, 2014 6:20:54 GMT -5
Nice job. Tell us how you did it (please).
|
|
t140v
3rd Gear
Posts: 422
|
Post by t140v on Sept 2, 2014 10:39:06 GMT -5
Nice job. Tell us how you did it (please). Hi Wayne, I have a small (ish) lathe in my garage and have been making bits and pieces for a couple of years now in 303 stainless steel, I made a small vent piece/breather that goes into the top of the rotor housing for Glenn Jenkins so was half way there, this is just a bit smaller same fitting, very tight and knocked in. If you ever need a repair I am open for buisiness. Regards Stuart. |
|
|
|
Post by wayne on Sept 2, 2014 19:48:45 GMT -5
Hmmm, I've gotten rid of my small lathe and got a medium sized job. I have no lathe skills as yet, just building up.
Here's something I can have a go at and then try and justify the purchase to the missus. She's so far been unimpressed with my rear shock preload spacers, my stainless peg rub knobs, my custom large OD small ID washers that Jap bikes seem to be full of.......what's a man got to do ? Perhaps if I knock her up an 80" HDTV on the lathe she'll see the value.
|
|
