|
|
Post by Glenn RE5 on Jan 31, 2013 14:04:17 GMT -5
Good pic of a core plug ready to burst, see the weep and staining of the rotor housing good advice given on this site to change them all on this bike, Attachments:
|
|
|
|
Post by HGH 770N on Feb 1, 2013 4:25:22 GMT -5
.Glenn this is as explaned on your other posting : 41 mm deep socket with a rattle gun is good or a long bar
you will need to put a socket on a extention bar through one of the three holes in the counter weight on to one of the bolt heads that you can see , this will stop the shaft turning while undoing the 41 mm nut .
Then you can use a 3 legged puller , Be sure to protect the thead on the end of shaft with a packer.
This is all shown in service manual.
Rog
deep socket with a rattle gun is good or a long bar ,
you will need to put a socket on a extention bar through one of the three holes in the counter weight on to one of the bolt heads that you can see , this will stop the shaft turning while undoing the 41 mm nut .
Then you can use a 3 legged puller , Be sure to protect the thead on the end of shaft with a packer.
Rog
|
|
