|
Post by drewsbrews on Apr 19, 2012 11:01:28 GMT -5
The plastic nipple is broken on the carb enrichment valve cover. Short of finding a direct replacement.. Initial thoughts were to maybe drill out the plastic and tap it for a bleeder nipple. Anyone else dealt with this?
|
|
|
Post by bdalameda on Apr 19, 2012 11:48:58 GMT -5
Almost every carb I have seen this nipple shows signs of deterioration. Many fit loose. I have had to epoxy the nipple on my carb. I would think that putting an air fitting nipple for small pneumatic controls would work fine.
|
|