|
Post by shavron on Aug 25, 2008 13:27:30 GMT -5
What paint do you use on the Rotor Emblem found on the main, left-hand cover and right-hand clutch release adj. cap?
|
|
Tonny
2nd Gear
Posts: 124
|
Post by Tonny on Aug 27, 2008 13:32:55 GMT -5
I have not tried to paint them. I just bought two new reproduction emblems from Rotary Recycle.
Tonny
|
|
|
Post by shavron on Sept 8, 2008 6:20:21 GMT -5
How hard was it to get the old ones off, and what did you use to glue the new ones on? Also did you need to reshape the new ones at all?
|
|
Tonny
2nd Gear
Posts: 124
|
Post by Tonny on Sept 9, 2008 6:09:55 GMT -5
Sorry, but I have not mounted the new emblem yet. Here is what Sam from Rotary Recycle write on his page.
Parts number: 68235-37001
"Use a hair dryer to remove the old emblems. Clean out emblem cavity seat with solvent. Glue new emblem in place. Time: 5 min."
-Tonny
|
|
|
Post by suzsmokeyallan on Sept 9, 2008 8:09:21 GMT -5
How about using some of the thin two sided grey tape. Cut it to fit the back of the emblem and trim to suit. If you care to attempt repainting your emblem soak it first in some solvent to remove the old paint residue and wash and dry it carefully. Some of the high temp modellers paint these days is very durable, so a visit to the shop for correct colours is whats needed plus a steady hand and some fine brushes.
|
|
|
Post by suzukiclub on Jan 11, 2009 9:19:36 GMT -5
What paint do you use on the Rotor Emblem found on the main, left-hand cover and right-hand clutch release adj. cap? Try a red or blue marker pen.worked for me
|
|
|
Post by ziggystardust on Jan 12, 2009 7:06:54 GMT -5
Super glue worked fine for me.
|
|
|
Post by Jess on Jan 13, 2009 23:26:43 GMT -5
I use 3M trim adhesive...
Whatever works...
Best,
Jess
|
|