|
Post by charles on May 14, 2018 13:18:39 GMT -5
GMN Bearing has responded and may be able to help. They need:
clutch specific part number, shaft diameter, hub bore diameter, clutch thickness, etc? It might help to get some pictures as well. The shaft and hub diameter as well as the width.
That's from 2 E-Mails. I sent a picture of the sprag clutch. The inner ring inner diameter is 5 cm. I also sent the Parts Diagram of the gear, sprag, etc., as found on another Thread here. I might be able to send him the measurements of the cardboard boxes that held the parts (before the boxes got wet) but not much more right now.
Any help would be appreciated as it would show access to parts not available for decades. If my contact will OK all of us knowing his GMN E-Mail, I'll publish it.
Thanx all,
Charlie
|
|
|
Post by timpa136 on May 14, 2018 13:24:19 GMT -5
GMN Bearing has responded and may be able to help. They need: clutch specific part number, shaft diameter, hub bore diameter, clutch thickness, etc? It might help to get some pictures as well. The shaft and hub diameter as well as the width. That's from 2 E-Mails. I sent a picture of the sprag clutch. The inner ring inner diameter is 5 cm. I also sent the Parts Diagram of the gear, sprag, etc., as found on another Thread here. I might be able to send him the measurements of the cardboard boxes that held the parts (before the boxes got wet) but not much more right now. Any help would be appreciated as it would show access to parts not available for decades. If my contact will OK all of us knowing his GMN E-Mail, I'll publish it. Thanx all, Charlie Thanks for the leg work, others may help with some needed info.
|
|
|
Post by Jess on May 14, 2018 13:46:15 GMT -5
Gmh bearing was who I was working with to have them made.
They are a non stocked item. But they told me they can make them.
All of the information in the group buy thread about cost and time should be accurate.
If someone wishes to do a group buy of them... best of luck to you.
Regards
|
|